Intelligent Machines

Graphene Helps Copper Wires Keep Their Cool

An exotic form of carbon could help relieve a growing problem with the copper used in computer processors.

As computers become more powerful, we’ll need new ways of cooling their components.

When people in the chip industry talk about the thermal problems in computer processors, they get dramatic. In 2001, Pat Gelsinger, then vice president of Intel, noted that if the temperatures produced by the latest chips kept rising on their current path, they would exceed the heat of a nuclear reactor by 2005, and the surface of the sun by 2015. Fortunately, such thermal disaster was averted by slowing down the switching speeds in microprocessors, and by adopting multicore chip designs in which several processors run in parallel.

Cooling off: A close-up shows copper before graphene has been added (top), and after (below).

Now the semiconductor industry has another thermal problem to sort out. As chip components shrink, the copper wiring that connects them must shrink, too. And as these wires get thinner, they heat up tremendously.

A potential solution to this interconnect fever has been found in the form of graphene, an exotic material made from single-atom-thick sheets of carbon that is a superlative conductor of both electrons and heat.

Materials scientists already use copper as a catalyst to grow graphene for other uses. So Alexander Balandin of the University of California, Riverside, and Kostya Novoselov, a physicist at University of Manchester, U.K., who won the 2010 Nobel Prize in Physics for his foundational work with graphene (see “Graphene Wins Nobel Prize”), decided to leave the graphene on the copper to see how it affected the metal’s thermal properties. In a paper published in the journal Nano Letters, they report that a sandwich made of graphene on both sides of a sheet of copper improves the copper’s ability to dissipate heat by 25 percent—a significant figure for chip designers.

Balandin says that the graphene itself doesn’t seem to conduct the heat away. Rather, it alters the structure of the copper, improving the metal’s conductive properties. Heat moving through copper is usually slowed by the crystalline structure of the metal. Graphene changes this structure, causing those walls to move farther apart, and allowing heat to flow more readily, says Balandin.

Studies were done with relatively thick sheets of copper—much larger than the copper wires found in computer chips—but Balandin expects that the heat-conducting effect will be seen in thinner copper wires, too. He’s now working on copper-graphene wires as small as those used in commercial computer chips.

The problem is an urgent one. This year, Intel is expected to announce products containing 14-nanometer transistors, with copper interconnects about on this scale or even smaller. Copper wires will not work below 10 nanometers, and it’s not clear what will. “We haven’t yet found an interconnect material that can work beyond 10 nanometers,” partly due to overheating, says Saroj Nayak, a physicist at the Center for Integrated Electronics at the Rensselaer Polytechnic Institute in Troy, New York.

Majeed Foad, an electrical engineer at Applied Materials, a semiconductor-equipment maker headquartered in Santa Clara, California, who helps the company track research on new materials, says graphene’s properties are exciting, but adds that as chip components are miniaturized, they become more sensitive to high temperatures. It takes a lot of heat to make good quality graphene—Balandin and Novoselov heated their wires to over 1,000 °C. Foad says such temperatures would degrade transistors and other chip components. Balandin, however, points to lab experiments that demonstrate that graphene can be grown at lower temperatures, at least in the research setting.

Regardless, Foad says, chip makers won’t be in any rush to embrace graphene. “Changing materials is very painful, so we will squeeze every last drop of performance out of what we have,” he says.

It’s clear that simply cramming more transistors into processors and putting more processors in chips is not going to be tenable much longer. High-end chips already contain about 50 to 60 kilometers of copper wiring and multiple cores.

Jonathan Candelaria, director of interconnect research at the Semiconductor Research Corporation, an industry consortium in Durham, North Carolina, says that adding more transistors doesn’t improve performance the way it used to. The solution may again turn out to be adopting fundamentally different architectures. New ways of designing and packaging chips could help solve the heat problem, says Candelaria, and this will give the industry time to work out problems with new materials, perhaps including the new graphene-copper hybrids.

Tech Obsessive?
Become an Insider to get the story behind the story — and before anyone else.

Subscribe today

Uh oh–you've read all of your free articles for this month.

Insider Premium
$179.95/yr US PRICE

More from Intelligent Machines

Artificial intelligence and robots are transforming how we work and live.

Want more award-winning journalism? Subscribe to Insider Plus.
  • Insider Plus {! !}*

    {! insider.display.menuOptionsLabel !}

    Everything included in Insider Basic, plus ad-free web experience, select discounts to partner offerings and MIT Technology Review events

    See details+

    What's Included

    Bimonthly magazine delivery and unlimited 24/7 access to MIT Technology Review’s website

    The Download: our daily newsletter of what's important in technology and innovation

    Access to the magazine PDF archive—thousands of articles going back to 1899 at your fingertips

    Special discounts to select partner offerings

    Discount to MIT Technology Review events

    Ad-free web experience

You've read all of your free articles this month. This is your last free article this month. You've read of free articles this month. or  for unlimited online access.