Skip to Content
Climate change and energy

A Better Way to Get Hydrogen from Water

Caltech researchers demonstrate a clean technique for using heat and catalysts to split water into hydrogen and oxygen.
June 19, 2012

An experimental approach to splitting water might lead to a relatively cheap and clean method for large-scale hydrogen production that doesn’t require fossil fuels. The process splits water into hydrogen and oxygen using heat and catalysts made from inexpensive materials.

Mark E. Davis

Heat-driven water splitting is an alternative to electrolysis, which is expensive and requires large amounts of electricity. The new approach, developed by Caltech chemical-engineering professor Mark Davis, avoids the key problems with previous heat-driven methods of water splitting. It works at relatively low temperatures and doesn’t produce any toxic or corrosive intermediate products.  

Almost all the hydrogen used now in industrial processes, such as making gasoline, comes from reforming natural gas. If automakers start selling large numbers of hydrogen-fuel-cell vehicles, as they’ve said they plan to do eventually, the hydrogen for those is also likely to come from natural gas unless processes like the one at Caltech are commercialized.  

The basic approach in high-temperature water splitting is to heat up an oxidized metal to drive off oxygen, then add water. In Davis’s case, the starting material is manganese oxide, and the reactions are facilitated by shuttling sodium ions in and out of it. “Without the sodium, the temperatures would go up well over 1,000 °C,” Davis says. With it, the reactions work at temperatures of 850 °C or lower.

The technology is probably far from being commercialized. It still requires pretty high temperatures—a couple of hundred degrees higher, for example, than those used to drive steam turbines at coal and nuclear power plants. Producing those temperatures without fossil fuels would probably involve one of two technologies, neither of which is being used commercially right now: high-temperature nuclear reactors or high-concentration solar thermal facilities that use rings of mirrors to concentrate sunlight more intensely than occurs today in solar thermal power plants. 

The Caltech approach would also need to be tested to make sure the water-splitting cycle can run repeatedly. So far, the researchers have shown that the same materials can be reused five times, but “if you were going to have one of these things work for real, you’d need to run it for thousands of cycles,” Davis says. He says such testing is beyond the scope of his lab. “We feel good about the potential for many cycles on this one, but until you do it, you don’t know,” he says. “All we did here is prove the chemistry could work.”

The rate of hydrogen production would also need to be increased—for example, by switching to materials with a higher surface area. And Davis hopes to lower the temperatures needed still further. The goal is to use this process or a similar one to make use of waste heat at steel mills and power plants. “This is a good start, but the lower we go, the better,” he says.

Deep Dive

Climate change and energy

Harvard has halted its long-planned atmospheric geoengineering experiment

The decision follows years of controversy and the departure of one of the program’s key researchers.

Why hydrogen is losing the race to power cleaner cars

Batteries are dominating zero-emissions vehicles, and the fuel has better uses elsewhere.

How virtual power plants are shaping tomorrow’s energy system

By orchestrating EVs, batteries, and smart home devices, VPPs can help make the grid cleaner and more efficient.

Trump wants to unravel Biden’s landmark climate law. Here is what’s most at risk.

The Inflation Reduction Act’s support for EVs and clean power could land on the chopping block if the Republican front-runner returns to the White House.

Stay connected

Illustration by Rose Wong

Get the latest updates from
MIT Technology Review

Discover special offers, top stories, upcoming events, and more.

Thank you for submitting your email!

Explore more newsletters

It looks like something went wrong.

We’re having trouble saving your preferences. Try refreshing this page and updating them one more time. If you continue to get this message, reach out to us at customer-service@technologyreview.com with a list of newsletters you’d like to receive.