A new way to make advanced lithium-ion battery materials addresses one of their chief remaining problems: cost. Arumugam Manthiram, a professor of materials engineering at the University of Texas at Austin, has demonstrated that a microwave-based method for making lithium iron phosphate takes less time and uses lower temperatures than conventional methods, which could translate into lower costs.
Lithium iron phosphate is an alternative to the lithium cobalt oxide used in most lithium-ion batteries in laptop computers. It promises to be much cheaper because it uses iron rather than the much more expensive metal cobalt. Although it stores less energy than some other lithium-ion materials, lithium iron phosphate is safer and can be made in ways that allow the material to deliver large bursts of power, properties that make it particularly useful in hybrid vehicles.
Indeed, lithium iron phosphate has become one of the hottest new battery materials. For example, A123 Systems, a startup based in Watertown, MA, that has developed one form of the material, has raised more than $148 million and commercialized batteries for rechargeable power tools that can outperform conventional plug-in tools. The material is also one of the types being tested for a new electric car from General Motors.
But it has proved difficult and expensive to manufacture lithium iron phosphate batteries, which cuts into potential cost savings over more conventional lithium-ion batteries. Typically, the materials are made in a process that takes hours and requires temperatures as high as 700 °C.
Manthiram’s method involves mixing commercially available chemicals–lithium hydroxide, iron acetate, and phosphoric acid–in a solvent, and then subjecting this mixture to microwaves for five minutes, which heats the chemicals to about 300 °C. The process forms rod-shaped particles of lithium iron phosphate. The highest-performing particles are about 100 nanometers long and 25 nanometers wide. The small size is needed to allow lithium ions to move quickly in and out of the particles during charging and discharging of the battery.
When designing an embedded system choosing which tools to use often comes down to building a custom solution or buying off-the-shelf tools.