A new photovoltaic material performs as well as the one found in today's best solar cells, but promises to be significantly cheaper. The material, created by researchers at Caltech, consists of a flexible array of light-absorbing silicon microwires and light-reflecting metal nanoparticles embedded in a polymer.

Computational models suggest that the material could be used to make solar cells that would convert 15 to 20 percent of the energy in sunlight into electricity--on par with existing high-performance silicon cells. But the material would require just 1 percent of the materials used today, potentially leading to a dramatic decrease in costs. The researchers were led by Harry Atwater, professor of applied physics and materials science at Caltech.

The key to the new material's performance is its ability to trap light. The longer a photon bounces around inside the active part of any solar cell, the greater the chance it will dislodge an electron. All high-performance solar cells have antireflective coatings that help trap light. But these cells use require far more silicon and must be sawed from wafers, a wasteful process.

"The promise of light trapping has always been that you could use less silicon and bring the costs down, but it's been difficult to implement," says Eli Yablanovitch, professor of electrical engineering at the University of California, Berkeley, who was not involved with the research.

Many groups have turned to structures such as nanowires and microwires in an effort to solve this problem. The Caltech group's photovoltaic material, which uses silicon microwires, demonstrates a new level of performance largely due to the addition of reflective nanoparticles.

Atwater's group grew arrays of silicon microwires from a gas on the surface of a reusable template. The template dictates how thickly the forest of wires will grow, and the diameter of each wire. The arrays are arranged sparsely, and without further treatment, make a poor solar material. But the wires are treated with an antireflective coating and coated in a rubbery polymer mixed with highly reflective alumina nanoparticles. Once the polymer sets, the entire thing can be peeled off like a sticker. Over 90 percent of the resulting material is composed of the cheap polymer, and the template can be used again and again.

"These materials are pliable, but they have the properties of a silicon wafer," says Atwater. When light hits the composite solar mats, it bounces around, reflecting off the alumina particles until it can be absorbed by a microwire.