Computing

The Atomic Battery

A breakthrough in betavoltaics could mean a 10-year battery life for sensors and medical implants.

  • June 16, 2005
  • By Eric S. Brown

The typical future-tech scenario calls for millions of low-powered radio frequency devices scattered throughout our environment -- from factory-floor sensor arrays to medical implants to smart devices for battlefields.

Because of the short and unpredictable lifespans of chemical batteries, however, regular replacements would be required to keep these devices humming. Fuel cells and solar cells require little maintenance, but the former are too expensive for such modest, low-power applications, and the latter need plenty of sun.

A third option, though, may provide a powerful -- and safe -- alternative. It's called the Direct Energy Conversion (DEC) Cell, a betavoltaics-based "nuclear" battery that can run for over a decade on the electrons generated by the natural decay of the radioactive isotope tritium. It's developed by researchers at the University of Rochester and a startup, BetaBatt, in a project described in the May 13 issue of Advanced Materials and funded in part by the National Science Foundation.

Because tritium's half-life is 12.3 years (the time in which half of its radioactive energy has been emitted), the DEC Cell could provide a decade's worth of power for many applications. Clearly, that would be an economic boon -- especially for applications in which the replacement of batteries is highly inconvenient, such as in medicine and oil and mining industries, which often place sensors in dangerous or hard-to-reach locations.

"One of our main markets is for remote, very difficult to replace sensors," says Larry Gadeken, chief inventor and president of BetaBatt. "You could place this [battery] once and leave it alone."

Betavoltaic devices use radioisotopes that emit relatively harmless beta particles, rather than more dangerous gamma photons. They've actually been tested in labs for 50 years -- but they generate so little power that a larger commercial role for them has yet to be found. So far, tritium-powered betavoltaics, which require minimal shielding and are unable to penetrate human skin, have been used to light exit signs and glow-in-the-dark watches. A commercial version of the DEC Cell will likely not have enough juice to power a cell phone -- but plenty for a sensor or pacemaker.

The key to making the DEC Cell more viable is increasing the efficiency with which it creates power. In the past, betavoltaics researchers have used a design similar to a solar cell: a flat wafer is coated with a diode material that creates electric current when bombarded by emitted electrons. However, all but the electron particles that shoot down toward the diodes are lost in that design, says University of Rochester professor of electrical and computer engineering Phillipe Fauchet, who developed the more-efficient design based on Gadeken's concept.

The solution was to expose more of the reactive surface to the particles by creating a porous silicon diode wafer sprinkled with one-micron wide, 40 micron-deep pits. When the radioactive gas occupies these pits, it creates the maximum opportunity for harnessing the reaction.

As importantly, the process is easily reproducible and cheap, says Fauchet -- a necessity if the DEC Cell is to be commercially viable.

The fabrication techniques may be affordable, but the tritium itself -- a byproduct of nuclear power production -- is still more expensive than the lithium in your cell-phone battery. The cost is less of an issue, however, for devices designed specifically to collect hard-to-get data.

Print

Related Articles

Harnessing Kinetic Energy

A microgenerator could power portable devices for troops.

Higher-Capacity Lithium-Ion Batteries

Nanostructured electrodes and active materials could shrink batteries for portable electronics and electric vehicles.

Cheaper Fuel Cells

A new membrane makes fuel cells more powerful and less expensive to produce.

Advertisement

MAGAZINE

Iridescent Displays

Qualcomm uses the ­mechanism that gives color to butterfly wings to make low-power, full-color e-reader displays.

Sponsored Content

Technologies from National Instruments

Triggering
Learn how to configure a start trigger on a USB data acquisition device

> Click here for more National Instruments Videos <
Whitepaper

How To Measure Voltage

Voltage is the difference of electrical potential between two points of an electrical or electronic circuit, expressed in volts. It measures the potential energy of an electric field to cause an electric current in an electrical conductor.

Most measurement devices can measure voltage. Two common voltage measurements are direct current (DC) and alternating current (AC).

Learn the fundamentals of creating an AC or DC voltage measurement system. See how to properly connect the signals to your data acquisition system for accurate acquisition.

This document is part of the How-To Guide for Most Common Measurements centralized resource portal.

View full PDF > Listen to story >
Find us on Youtube

Videos

Interview with George Dyson

More

Advertisement
Advertisement
Advertisement